With our latest releases - you can now add a logo on a generated images. However, if you wish to add a logo on an existing image - there's no consistent steps that can be taken because:
Image editing is not supported yet in Sintra, which is required to layer images well;
When working with images - image generation models are used and they may reference your logo well; however, it's not guaranteed because these models are trained to create visually plausible images, not to interpret geometry or scale. They don’t inherently “understand” dimensions or measurements, so their outputs might look good but aren’t to scale or structurally accurate.
Generating an image with your logo
If you wish to generate an image with your logo, you need to:
Go to a chat with a Helper
In the message field, do all of the following:
Upload your logo to the chat.
Write a prompt for the image you wish to be generated.
Include "place the logo" in your prompt and clarify the size and placement of the image.
Then you'll receive a generated image with your logo on it!
Important notes:
The images generated will be the size of the original logo file that was uploaded. This size cannot be adjusted during image generation.
You can use the same logic with any image with a transparent background to achieve the desired outcome.
Each time you wish to regenerate an image containing your logo - you must upload the logo image with your prompt; otherwise, the Image model will craft and image where the logo is inspired by the previous image.